COMFOOT HOLE REPAIR KIT
Long lasting heavy duty repair which hardens normally within 2 hours
Comfoot hole repair is the solution for area's where repair situation is easier than having to remove old worn concrete which involves removal of old concrete to achieve the depth required.
With Comfoot there's no problem with this time consuming exercise. You just prime the area involved then fill to the required depth. Depth to fill 10mm+ instructions
Time taken to undertake this job is minutes and is hard enough to walk on usually in 2 hours. Heavy traffic within 48 hours. Not only can you repair the offending hole the surrounding area too can be covered with a depth of 3mm to give a lasting dust free finish and colours can be added.
Comfoot Hole Repair is a two-part pack & is easy to use. Supplied in 5- 10 kg packs powder with 1-2 litres of Acrylic emulsion . Just follow the instructions on how to use. Coverage 10kgÝ = 1sq. metre @ 8mm thick
Comfoot Hole Repair Kit is used in area's where damaged, broken concrete creates a problem for safety or vehicle access i.e.: forklifts, trolleys, paths, patios, garages etc. Used inside or outside.
Can be used in conjunction with Comfoot Flooring screeds for a smooth non-slip floor surface to worn or vulnerable areas
INSTRUCTIONS:
Area to be treated must be clean and free from contamination of oils etc. Area to be treated should be primed to allow adhesion of product using equal volume. Wait to dry use fill mix powder with Acrylic emulsion to consistency required normally 750-1000mlÝ to 10kg powder. Leave to harden before walking on. Protect from frost until hardened. For area's <3mm or to enhance floor area we would recommend Comfoot Screed which can be coloured/waterproofed.
