Comfoot Flooring - Floor coatings, Laminate flooring, Bathroom heating

underfloor heating electric devi

devireg® 550 Setup Instructions

If the thermostat is displaying 'CODE', initially you will ONLY be presented with step 1 and step 4, set these as described below.

Once you have either completed steps 1 and 4, or the controller is displaying something other than 'CODE', you must press and hold the button until the word 'CODE' is displayed and follow the steps below:

Step 1 - Setup Code		Rotate button to select code 0044 and then press button once.



Step 2 - Operating Mode		Rotate button to select 'ALO' and the press button.


Step 3 - Temperature Readout		Rotate button to select °C and then press button.
Step 3 - Temperature Readout


Step 4 - Sensor Selection		Mat systems:- Rotate button to select 'FS' (not rFs or rs) to activate the floor sensor, then press button. Reading will not show temperature scale only 1-10
		Cable systems select rFs. Temperature scale will be shown.

Step 5 - Maximum Floor Temperature		At 'nt' rotate button to select either of the following maximum floor temperatures, then pres button. Tiles on timber based floors 27°C - 31°C Tiles on concrete based floors 40°C Timber covered floors(laminate etc.) 27°C
Step 5 - Maximum Floor Temperature


Step 6 - Off Periods		'LO' should be displayed, you should rotate dial to select -15°C, then press button.


Step 7 - Clock Display		Rotate button to select clock display as either 24 hours or 12 hours AM/PM.



Step 8 - Save Settings		Press button once.
Step 8 - Save Settings

	If the controller is now displaying CODE, disconnect the power to the controller and then reconnect		TIMER SETUP

under floor heating uk, tile heating underfloor, floor coatings, garage workshop floor coatings, epoxy floor coatings, industrial floor coatings screeds, laminate flooring, conservatory heating, lounge heating, kitchen heating, bathroom heatingComfoot screed is a two part bathroom heating pack, which consists of acrylic emulsion. Mixed with the powder (limestone-silica sand-cement-polymers-rapid hardeners) this creates a heavy epoxy floor coatings, industrial floor coatings screeds duty surface floor coatings, garage workshop floor coatings even at 3mm thick. Self levelling. It is an ideal medium for thin screed applications to under floor heating. Very hard wearing and accepts 40 floor coatings, garage workshop floor coatings tonne lorries under floor heating uk, tile heating underfloor after only 48 hours. Mixed with either granite bathroom heating chippings or fine powder fills holes, permanently. Care has to be taken on installation, due to it's rapid curing time, you can walk on it within 1 hour in normal conditions. Protein free harbours no bacteria and slow laminate flooring, conservatory heating to biodegrade. Non-slip under floor heating uk, tile heating underfloor properties in lounge heating, kitchen heating various situations. In livestock floor coatings, garage workshop floor coatings situations Comfoot is a very versatile product which is very hard wearing, resistant to pressure epoxy floor coatings, industrial floor coatings screeds washers and acids in diets or excrement. Even livestock lounge heating, kitchen heating cannot attack the surface, laminate flooring, conservatory heating but it is gentle enough to protect tiny delicate knees, which are a concern lounge heating, kitchen heatingto many livestock enterprises. Even concrete slats can be repaired to their laminate flooring, conservatory heatingnormal state, cost saving and effort in removing bathroom heating and reinstalling new under floor heating uk, tile heating underfloor slats. Being protein free Comfoot cannot harbour bacteria, unlike bathroom heating concrete surfaces. So when the surface is cleaned again and a propriety disinfectant under floor heating uk, tile heating underfloor used, the floor is sterile, epoxy floor coatings, industrial floor coatings screeds therefore reducing pathogen build up ensuring floor coatings, garage workshop floor coatings optimum profit.