Concrete
Degreaser is
a fast acting, deep penetrating degreasant for use either before repair or
coating, or simply for improving the appearance of stained concrete. Dissolves
even the thickest oil and grease deposits.
General:
Floorsaver Degreaser is a highly effective alkaline liquid emulsion
cleaner containing an aromatic solvent. It is ideal for cleaning dirty
and oily concrete floors in workshops, factories, assembly shops and
garages, also for degreasing metal components and assemblies.
Application:
Pour onto floor and thoroughly scrub in, preferably with electric
floor scrubbing machine. Leave for 10 minutes and wash or hose off the
emulsified dirt and grease. Excess liquid may readily be removed with
squeegee, mop or wet vacuum pick-up.
Note:
It is essential that the floor is allowed to dry completely after
degreasing and prior to applying a floor coating or repair mortar (see
Floorsaver data). It is important to inspect the cleaned floor and
ensure it is dry and free from oil before coating commences.
Storage:
Should not be stored at temperatures below 0°.
Technical
Service: A full application and advisory service is
available.
Safety:
Detailed Health and Safety information is available.
Concrete
Etching Fluid is a brush
on surface conditioner for concrete prior to coating, ensuring good adhesion.
This product will remove weak or dusty laitence on concrete. Concrete Etching
Fluid can also be used to texture the surface of power floated concrete to
provide a slip resistant surface at low cost.
General:
Floorsaver Etching Fluid is used to prepare concrete prior to
painting. It helps remove the surface dust (laitence) that is often
evident on concrete. It is also frequently used to effect a slightly
textured surface for enhancing slip and skid resistance on smooth,
hard concrete floors.
Surface
Preparation: Ensure that the surface of the concrete is free
from oil and grease. This may be achieved by the use of Floorsaver
Degreaser..
Application:
Floorsaver Etching Fluid is supplied ready to use. It should be
applied evenly to the concrete and scrubbed in. For large areas a
combined scrubber/wet vacuum machine will greatly assist the process.
Reaction should be allowed to take place for approximately 10 minutes
after which the floor should be thoroughly washed and dried. When
Floorsaver Etching Fluid is used to impart a slip resistant texture
onto hard or chemically treated concrete it may be necessary to carry
out the etching process twice. We recommend that a trial area is
treated..
Storage:
Store in a cool dry place away from direct sunlight. Do not allow to
freeze.
Pack
Size/Coverage: Approximately 20 mē per 5 litre pack and 100
mē per 25 litre pack.
Cleaning:
Applicators may be cleaned with water.
Technical
Service: A full application and advisory service is
available.
Safety:
Detailed Health and Safety information is available.
